Metal Gates in Cedar Park, TX

Call today for a free estimate, and we will measure your Cedar Park driveway before a single tube is cut.

Sofia in Twin Creeks had a flat driveway too short behind the line for any swing leaf to clear a parked truck. We set a 14 ft galvanized leaf on V-track, with the track surface-mounted over a drain slot and a side-mounted pad operator, so the leaf clears the truck bumper and the track stays free of standing water after storms. It was an estimated $2,700 to $4,200 job that took an estimated 2 to 3 days.

Bradley in Silverado was torn between aluminum and steel, and a detention pond kept the ground wet near his posts. We drew the coating and the tube on the estimate for a 14 ft pair of hot-dip galvanized steel under powder coat, which let him choose from a side-by-side sheet, and the pair has kept its finish at the post bases. The job was an estimated $4,400 to $6,000 over an estimated 2 to 3 days.

Patrice at the Ranch at Cypress Creek sat on a board replacing failed entry gates while residents still needed to get out every morning. We changed one lane at a time, added a directory panel on a telephone entry system and wrote a reserve plan for the operators, so one lane stayed open each workday and the board received a written 10-year parts plan. The estimated range was $9,500 to $14,500, and the work took an estimated 4 to 6 days.

What a Cedar Park Gate Costs

Leaf type, opening width and operator move a Cedar Park gate price more than anything else. The table shows the jobs we quote most often, and every number is an estimated range.

A two-leaf automated swing entry is an estimated $4,300 to $7,900 and takes an estimated 2 to 3 days. A walk-through entry gate is an estimated $700 to $1,400 over an estimated 4 to 8 hours. A scheduled gate service plan is estimated at $89 to $112 per gate per month, with visits of an estimated 1 to 3 hours. All of these numbers are estimates, subject to change. The written quote sets the final price and the install schedule, and what lands in it depends on the opening width, any posts you already own and the access gear you choose.

What Can Go Wrong With a Gate Install

The most common failure is a gate sized for the opening but not for the driveway behind it, as with Sofia's flat driveway too short behind the line for any swing leaf to clear a parked truck. We mark the arc and the slide tail on the ground at the first visit.

Footings are the second risk. We set belled piers 36 in or deeper, and a heavy leaf on a shallow post will sag within a season. Emergency entry comes next, so we fit a Knox key switch, a siren sensor or a strobe sensor as the fire marshal asks. Grade follows: gentle ground gets racked panels and steep lots get stepped ones. Safety is last: every operator we install gets monitored photo eyes, so a gate that closes on a bumper or a child stops and reverses.

Metal Gate Service Areas Near Cedar Park

Our crews work Georgetown, Round Rock, Lakeway and Steiner Ranch every week from a 35 mile radius around the Leander shop, including metal gates in Leander, Georgetown, Round Rock and Lakeway, plus Steiner Ranch, Volente and The Hills on our service area page.

Set Up a Free Gate Site Visit in Cedar Park

Ask for a free estimate and we will measure the opening, sketch the layout and hand you a written, itemized quote.