Leander Metal Gates is the metro's trusted expert in solar gate operators, specializing in electric gate repair, automatic gate repair, and gate opener repair. We offer ranch entry gates and steel fencing built in our own shop.
Our team provides gate access control and gate operator installation, with the footings, operators and finishes done for residential and commercial projects alike. After 14 years in business, and with a 2-year workmanship warranty on weld integrity, post plumb, hinge alignment and gate sag, we have completed 1,127 projects that range from one walk gate to a multi-lane community entry.
From a walk-through entry gate up to a scheduled gate service plan, our team handles each job with one crew. Serving Volente and neighboring Lakeway, Steiner Ranch and The Hills, we size each operator to the winter sun and the lot in front of it.
Book a free estimate, and our Volente location manager will walk the lot, test the gate and sketch the fix before anything is ordered.
Hank, Lime Creek Road, Volente
A lower gate on a steep lot, 300 feet of rock from the nearest panel, under heavy cedar shade
Ruth, Volente Road, Volente
A dead keypad and blown board after a hilltop storm, with a motor that still tested good
Investment and duration figures are estimates. Your written quote sets the final price and schedule.
Numbers first
Hank on Lime Creek Road had a lower gate on a steep lot, 300 feet of rock from the nearest panel, under heavy cedar shade. We set an oversized panel on a pole above the canopy with dual batteries and an arm operator for one 14 ft leaf, an estimated $2,000 to $3,100 job that typically took 4 to 8 hours, and no trench was cut across the rock.
Ruth on Volente Road had a dead keypad and blown board after a hilltop storm, with a motor that still tested good. We replaced the board and transformer, added surge protection and grounded the pedestal, an estimated $850 to $1,650 job with an estimated install of 4 to 8 hours, and the original motor stayed in service.
Volente sits on the north shore of Lake Travis as a village incorporated in 2003, home to about 561 people across 2.12 square miles. Lots here run long and rocky, so power is often the first problem, and a solar kit sized to the gate avoids trenching, while every operator keeps its battery backup and manual release.
Jurisdiction is the second check. Travis County handles fence permits outside city limits, and floodplain review can apply near the lake, so confirm with the village or the county whether your address falls under village or county rules before you plan a fence.
Storms are the third pattern. A hilltop strike can blow a board and leave a motor that still tests good, so we ground the pedestal and add surge protection when we replace a board.
A solar or retrofit operator in Volente is estimated at roughly $1,850 to $3,600, and the leaf weight, the panel size and the battery bank move the price most.
| Volente job | Est. investment | Est. time on site |
|---|---|---|
| Operator added to a manual gate | Est. $1,850 to $3,600 per operator | Est. 4 to 8 hours |
| One-leaf automated swing gate | Est. $2,600 to $4,800 per complete system | Est. 1 to 2 days |
| Walk-through entry gate | Est. $700 to $1,400 per gate installed | Est. 4 to 8 hours |
| Open-view steel fence line | Est. $51 to $84 per linear foot | Est. 2 to 4 days |
| Scheduled gate service plan | Est. $89 to $112 per gate per month | Est. 1 to 3 hours per visit |
Rock typically pushes a post job toward the top of its range, because footings are belled concrete piers 36 inches or deeper, with depth and rebar decided by what the auger hits at each post.
Every Volente figure here is an estimate, subject to change, and we commit to a final price and an install date only in a written quote, once we have seen the property.
Most owners start with solar gate operators for long drives and ranch entry gates for the road frontage, with powder-coated tube steel as the frame behind both. Finishing runs blast, then zinc primer, then polyester powder baked in the oven, and a touch-up kit is left behind for later scratches.
The process runs in four steps. First, we walk the lot, test the operator and measure the leaf, then set the clearance from the high point of the drive arc, usually 2 to 4 inches. Second, you approve a quote that sizes the panel and batteries to the winter sun and the daily cycles. Third, we fabricate any new steel in our shop and order the parts. Fourth, our crew installs and wires everything, then runs the operator, its monitored photo eyes and its edges through each entrapment zone at handover.
The same crew that tests a Volente gate fixes it, so the board, the motor and the pedestal get one diagnosis. Our Volente location manager books the install date and keeps the parts order moving. Our 2-year workmanship warranty stays with each Volente gate for weld integrity, post plumb, hinge alignment and gate sag, and the operator maker backs the operator separately. A solar panel, dual batteries and arm operator suit a Volente lot well when a power trench would have to cross rock and old tree roots.
We work across Volente, from the north shore to the lots up the hill, and our crews cross into Lakeway homes, Steiner Ranch properties and The Hills estates the same week. Every other town we cover is listed on the gate service area page.
Volente owners often pair a new operator with electric gate repair for the board and keypad, or add gate service contracts for scheduled visits.
Plan on roughly $1,850 to $3,600 for an operator, estimated, and your written quote sets the final price once we see the gate.
Yes, an oversized panel on a pole above the canopy, sized to the winter sun and daily cycles.
Confirm with the village or the county whether your address falls under village or county rules, and ask about floodplain review near the lake.
Most repairs take an estimated 4 to 8 hours on site once the parts arrive.
Often yes, replace the board and transformer, add surge protection and ground the pedestal.
Yes, a scheduled visit comes with a written log, and it catches worn hinges and sensors before either one fails.
Contact us today, and we will walk your Volente lot, test the gate and hand you a free written, itemized quote.
Your local contact
Names, photos and stories are on our about page.
Location manager covering Volente
Runs the schedule for Volente from the first site measure to the final safety test.
Where we work
Call us or send the form, and we will book a site measure and a written estimate.
Calls only, we do not receive text messages.
